Flush-Fit Installation - Miele KM 7999 FR Operating And Installation Instructions

Installation

Flush-fit installation

 Create the worktop cut-out. Remem-
ber to maintain the minimum safety
distances (see "Safety distances").
 Solid wood, tiled and glass worktops:
Fix a wooden frame 6 mm below the
top edge of the worktop (see build-
ing-in diagram for "Flush-fit installa-
tion").
 Stick the supplied sealing strip under
the edge of the hob. Do not apply the
sealing strip under tension.
 Feed the mains connection cable for
the hob down through the worktop
cut-out.
 Centre the hob in the cut-out.
The gap between the ceramic glass
surface and the worktop must be at
least 2 mm wide. This is required so
that the hob can be sealed.
 Connect the hob to the power supply.
 Check that the hob works.
 Seal the gap between the hob and
worktop with a silicone sealant that is
heat-resistant to at least 160 °C.

Damage from unsuitable sealant.
Unsuitable sealant can damage nat-
ural stone.
For natural stone worktops and nat-
ural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Follow the manu-
facturer's instructions.
80