Completing The Configuration - Cisco 3825 Software Configuration Manual

Chapter 3 First-Time Configuration
Step 10 Configure the specified interface as prompted.
Configuring interface GigabitEthernet0/0:

Completing the Configuration

When you have provided all the information prompted for by the setup command facility, the
configuration appears. Messages will be displayed that are similar to the following:
The following configuration command script was created:
!
hostname 3825-1
enable secret 5 $1$5fH0$Z6Pr5EgtR5iNJ2nBg3i6y1 enable password ciscoenable line vty 0 4
password ciscoenablesnmp-server community public !
no ip routing
!
interface GigabitEthernet0/0
no shutdown
media-type 100BaseX
full-duplex
ip address 178.18.44.233 255.255.255.128
!
interface GigabitEthernet0/1
shutdown
no ip address
!
end
To complete your router configuration, do the following:
A setup command facility prompt asks whether you want to save this configuration.
Step 1
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
[OK]
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
OL-15667-03
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]:yes
IP address for this interface: 178.18.44.233
Subnet mask for this interface [255.255.0.0] : 255.255.255.128
Class B network ia 178.18.0.0, 25 subnet bits; mask is /25
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
Completing the Configuration
3-7