Ipran-Mib Snmp-Access - Cisco 3825 Software Configuration Manual

ipran-mib snmp-access

ipran-mib snmp-access
Use the ipran-mib snmp-access command in the global configuration mode to define the type of
connectivity between the device and the network management system. It is used to limit the amount of
traffic when in band polling.
Syntax Description ipran-mib snmp-access ?
Defaults
inBand.
Command Modes Interface configuration
Command History Release
12.4(2)MR1
12.4(9)MR
Examples
Router# config t
Router(config)# ipran-mib snmp-access inBand
Router(config)# ipran-mib snmp-access outOfBand
Router(config)# ipran-mib snmp-access undefined
Router(config)# no ipran-mib snmp-access
Router(config)# exit
Related Commands
Command
ipran-mib location
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-52
ipran-mib snmp-access access
Modification
This command was introduced.
Support for utilization notification was removed. This command is supported to
maintain compatibility.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
inBand In Band SNMP connectivity.
•
outOfBand Out of Band SNMP.
•
undefined Undefined connectivity.
•
Description
Defines the location of the device. It is also used to assist the network
management system in properly displaying the topology of the
system.
OL-15667-03