Gsm-Abis Retransmit - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

gsm-abis retransmit

To enable retransmission of repetitive subrate sample, use the gsm-abis retransmit Interface
configuration command. This command is useful when the latency introduced by the characteristics of
the backhaul network is excessive. Examples are the use of satellite transmission facilities or multiple
router hops on the backhaul network.
Syntax Description sample-delay
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History Release
12.4(2)MR
Examples The following example shows how a retransmit delay of 100 ms:
Router(config)# interface Serial10/1/0.0
Router(config-if)# encapsulation gsm-abis
Router(config-if)# gsm-abis local 10.10.10.1 5504
Router(config-if)# gsm-abis remote 10.10.10.2 5504
Router(config-if)# gsm-abis retransmit 5
Related Commands Command
gsm-abis local
gsm-abis remote
show gsm-abis packet
show gsm-abis packet | include
retransmit
OL-15667-03
gsm-abis retransmit [sample-delay]
The number of duplicate samples that must be observed before the duplicate
sample will be retransmitted. The sample-delay in a range of 5 to 255 or 100
to 5100 ms at 20 ms intervals.
Modification
This command was introduced.
Description
Configures the local parameters for an IP/UDP backhaul
connection.
Configures the remote parameters for an IP/UDP backhaul
connection.
Displays packet statistics counters of the GSM
compression/decompression.
Displays packet statistics counters of the GSM
compression/decompression to include the repetitive sub-rate
samples retransmitted.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
gsm-abis retransmit
A-33