Cisco 3825 Software Configuration Manual page 106

Configuration Sequence
For example, the following command specifies the class as the llq-class.
Router(config-pmap)# class llq-class
When you enter the class command, you are in the class submode of the policy-map configuration mode.
Allocate a percentage of bandwidth to be used for the prority queue.
Step 3
Router(config-pmap-c)# priority percent number
For example, the following command specifies a priority percent number of 99.
Router(config-pmap-c)# priority percent 99
Associate the llq-policy with a default class map. The default class is used for non-priority traffic.
Step 4
Router(config-pmap-c)# class class - default
Allocate the remaining bandwidth to the default class.
Step 5
Router(config-pmap-c)# bandwitdh remaining percent number
For example, the following command specifies the remaining bandwidth as 1 percent.
Router(config-pmap-c)# bandwidth remaining percent 1
Limit the queue depth of the default queue.
Step 6
Router(config-pmap-c)# queue-limit number
For example, the following command limits the queue depth to 45.
Router(config-pmap-c)# queue-limit 45
The queue limit on the default class should be less than the hold-queue specified on the multilink
Note
interface.
Step 7 Exit the class map and policy map configuration modes.
Router(config-pmap-c)# exit
Router(config-pmap)# exit
For more information about these commands, see the Cisco IOS Quality of Service Solutions Command
Reference for your Cisco IOS Release.
Specify the Location of the Interface
Enter interface configuration mode and specify the location of the interface.
Step 1
Router(config)# interface atm slot /subslot/ port
For example, the following command specifies the location of the interface as ATM0/0.
Router(config# interface atm0/0/0
Disable the IP address configuration for the physical layer interface.
Step 2
Router(config-if)# no ip address
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-48
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
OL-15667-03