Cisco 3825 Software Configuration Manual page 200

redundancy
redundancy
To access the command mode that allows you to configure aspects of redundancy, use the redundancy
command in global configuration mode.
Syntax Description This command has no parameters; it invokes the redundancy mode.
Defaults
There are no default settings or behaviors.
Command Modes Global configuration
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
12.4(2)MR
Examples The following example enables redundancy mode:
Router(config)# redundancy
Router(config-r)
Related Commands Command
mode y-cable
standalone
standby use-interface
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-68
redundancy
Modification
This command was introduced.
This command was incorporated.
This command was incorporated.
This command was incorporated.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
Invokes y-cable mode.
Indicates whether the Cisco 3825 router is being used as a standalone
device and manually sets the relays.
Designates a loopback interface as a health or revertive interfaces.
OL-15667-03