Show Commands For Monitoring The Cisco 3825 Router - Cisco 3825 Software Configuration Manual

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line

Show Commands for Monitoring the Cisco 3825 Router

To monitor and maintain the Cisco 3825 router, use the following commands:
Command
show atm cell-packing
show cem circuit
show cem platform
show controllers
show controllers e1
show controllers fastethernet slot/port
show controllers gigabitethernet slot/subslot/port Displays information about initialization block,
show controllers t1
show gsm traffic
show gsm-abis efficiency [history]
show gsm-abis errors
show gsm-abis packets
show gsm-abis peering [details]
OL-15667-03
Purpose
Displays information about Layer 2 transport
ATM cell-packing.
Displays summary information about the CEM
circuit state, including controller, interface and
AC.
Displays specific CEM circuit state, circuit
parameters and statistics/counters in detail.
Displays CEM errors and information.
Displays all network modules and their interfaces.
Displays the status of the VWIC/HWIC relays
when a VWIC or HWIC is installed.
Displays information about the controller status
specific to the controller hardware. It also displays
statistics about the E1 link. If you specify a slot
and a port number, statistics for each 15 minute
period will be displayed.
Displays information about initialization block,
transmit ring, receive ring and errors for the Fast
Ethernet controller chip.
transmit ring, receive ring, and errors for Gigabit
Ethernet interface controllers.
Displays information about the cable length,
framing, firmware, and errors associated with the
T1. With the Cisco 3825 router, this command
also displays the status of the relays on the
VWIC/HWIC.
Displays traffic rates, in bits per second, at 1
second, 5 seconds, 1 minute, 5 minutes, and 1 hour
intervals for GSM data transmitted and received
over the backhaul.
Displays the history of the GSM efficiency
averages for compression/decompression at
1-second, 5-second, 1-minute, 5-minute, and
1-hour intervals.
Displays error statistics counters of the GSM for
compression/decompression.
Displays packet statistics counters of the GSM for
compression/decompression.
Displays peering status, statistics, and history of
the GSM compression/decompression.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
Monitoring and Managing the Cisco 3825 Router
4-71