Hammer Strength MTS HIGH ROW Unpacking And Assembly Instructions page 8

MTS HIGH ROW Assembly Instructions
3. Bolt the front brace to the sides. Insert the two upper ½" x 2-3/4" hex head bolts with
hammerhead washers from the outside of the MTS HIGH ROW into the locations shown at
left. Put on a star washer and hand tighten the locknuts so that the front brace will be easier to
install. Then insert the bottom two hex bolts, hammerhead washers, star washers and
locknuts.
1/2" x 2-3/4"
(4)
Assembly Figure 3. Bolt the front brace to the sides.
8
2-3/4" BOLT