Hammer Strength MTS HIGH ROW Unpacking And Assembly Instructions page 13

Hide thumbs Also See for MTS HIGH ROW:

Assembly Figure 8. Connect the belts to the weight stacks (30 ft/lbs).

Run the belts through the arm pulleys and bolt down the belts. Thread the belts from

the weight stacks through the arm pulleys to the belt plate. With the weight stack pin in

the bottom (150 lb.) plate, pull the belt until it's tight. Push up on the arm so that it's

resting on its bumper. Use the 3/8" x 1-1/4" bolts and plates and tighten down the belt to

20 ft/lbs. Cut off the belts leaving about one inch beyond the belt plate. Use a heavy

scissors or utility knife to cut off the belt.

Assembly Figure 9. Connect the belts to the arms and cut off excess.

NOTE: THE 3/8" STAR WASHERS THAT LOCK DOWN THE BELTS

TO THE ARMS WILL NEED TO BE REPLACED EACH TIME THE

BOLTS ARE LOOSENED FOR BELT MAINTENANCE.

3/8" x 1-1/4" (2)

MTS HIGH ROW Assembly Instructions

Cut off belt 1"

beyond belt plate