Hammer Strength MTS HIGH ROW Unpacking And Assembly Instructions page 6

Hide thumbs Also See for MTS HIGH ROW:

MTS HIGH ROW Assembly Instructions

1. Bolt the bottom brace to the left side of the MTS HIGH ROW. Slide the left side of the

MTS HIGH ROW up to the bottom brace and bolt it to the bottom brace using two of the ½" x

2-3/4" hex head bolts with hammerhead washers. Insert the bolts from the outside of the MTS

HIGH ROW. Place a star washer on each of the bolts before putting on the locknut. Loosely

tighten the locknuts so that the front brace will be easier to install. After the bolts are

tightened, place a rubber cap on the end of the bolt and over the nut.

Assembly Figure 1. Bolt the bottom brace to the left side of the MTS HIGH ROW.

1/2" x 2-3/4"

(2)

2-3/4" BOLT