Hammer Strength MTS HIGH ROW Unpacking And Assembly Instructions page 16

Hide thumbs Also See for MTS HIGH ROW:

MTS HIGH ROW Assembly Instructions

To apply the weight plate stickers:

1. Peel off the backing.

2. Line up sticker backing edge with holes as shown in the figure. Make sure you've

aligned the sheet so that the top hole in the stack (the one that holds the weight

stack pin) DOES NOT get a sticker.

3. Make sure the sheet of labels is straight.

4. Press down.

HAMMERHEAD WASHER LOCATIONS

Hammerhead washers (circled) on outside of

MTS HIGH ROW (10 each side)

Assembly Figure 12. Hammerhead washer locations.

Assembly Figure 12 shows the 24 bolt connections on the MTS HIGH ROW that need

hammerhead washers.

Hammerhead washers (circled) on inside of

MTS HIGH ROW (2 each side)