Hammer Strength MTS HIGH ROW Unpacking And Assembly Instructions page 12

MTS HIGH ROW Assembly Instructions
7. Bolt seat assembly to MTS HIGH ROW. Using the 1/2" x 2-3/4" bolts with star washers,
fasten the seat back and bottom to the bottom brace of the MTS HIGH ROW as shown at left.
Star washers go on the top and bottom of the bolt.
1/2" x 2-3/4" (4)
Assembly Figure 7. Bolt seat assembly to MTS HIGH ROW.
NOTE: THE STEP BELOW MAY HAVE BEEN COMPLETED AT THE
FACTORY.
8. Connect the belts to the weight stacks. Connect the belt to the weight stack by looping
the belt over the belt pin as shown below. Bolt down the belt plate to 30 ft/lbs.
NOTE: THE "RIBS" IN THE BELT SHOULD BE FACING THE BELT
PIN AS SHOWN BELOW.
12
2-3/4" BOLT