Notes On Using The Emulator Debugger; Notes On Connecting The Emulator Debugger - Renesas E2 Emulator User Manual

E2/E2 Lite
3.3

Notes on Using the Emulator Debugger

This section describes how to set the [Debug Configurations] window of the e
Configurations] window, click on [Run] → [Debug Configurations...] or the downward-pointing arrow next to
the icon→ [Debug Configurations...].
3.3.1

Notes on Connecting the Emulator Debugger

(1) Reset state
Under [Connection] on the [Connection Settings] tabbed page, be sure to select [Yes] for [Hold reset
during connect] (the operation is explained for the case when the e
When [Yes] is selected, during connection to the emulator debugger, the emulator maintains the low-level
output on the RES# pin of the MCU and places the MCU in the OCD mode. However, to start the
operation of the built-in debugging circuits of the MCU, the emulator releases the reset for about 50 msec
while it is connected, and the user program automatically runs during that period.
R20UT4582EJ0100 Rev.1.00
Jul.16.19
Figure 3.2 Opening the [Debug Configurations] Window
Figure 3.3 [Debug Configurations] Window
Notes on Usage
2
studio. To open the [Debug
2
studio is in use).
Page 20 of 30