Haier QBJ1-130A58E Instructions For Use Manual page 24

Using Instruction
(4)When water temperature is higher than 90 and there is no water in tank, in
order to protect the tube from bombing due to the sudden cold, the
system will forbid supplying water automatically ,even if user presses
the key , it won't be activated.
(5)In the process of water supply, water supply sign displays.
(6)Reaching the pre-set water level or being full of water for 10 seconds, it will
stop automatically.
(7)When the sensor occur error, water supply can be activated by pressing
key, and stop automatically 8minutes later. In the process of water supply,
the buzzer will buzz once per minute to remind user notice whether the water
overflows.
Instruction: calculate by water flow is 0.6-0.8 m/s and the water pipe is 1/2 pipe,
you can supply 70 liters water in 8 minutes.
.
2 Time water supply
(1)After the time reaches the pre-set value, if the water level is lower than the
set value, water supply will be activated automatically and stop until reaching the
pre-set water level.
(2)When displaying press key , the display goes out, time
water supply is cancelled. In this state, press key until
displays, it will be activated.
(3)In the process of water supply, sign displays.
(4)When the water reached the pre-set water level, water supply will stop
automatically in 10 seconds.
3.Manual heating
(1)When the temperature is lower than the set value and water level is higher
than 2nd grids, press key to activate electric heater and it will stop
automatically until reaching the pre-set temperature.
(2)When the water temperature lower than the pre-set valve and the water
level lower than 2nd level, press key to activate water supply until
the water level reaches 2nd level, the electric heater can be activated .
(3)In the process of electric heating, press key again, it will stop.
(4)In the process of heating, electric heating sign displays.
4.Time heating
(1)When the time reaches the pre-set value, if the water temperature lower than
6