Haier QBJ1-130A58E Instructions For Use Manual page 25

Installation Instruction
the pre-set value, electric heating will activate automatically until reaching the
pre-set temperature.
(2)If the water temperature lower than the set value and water level is lower
than two level, electric heating will be activated automatically.
(3)When displays, press key until the display dies out and time
electric heating is cancelled. In this state, press key until displays,
Time electric heating will be activated.
(4)In the process of heating, the electric heating sign is display.
5.Automatical water supply
(1)After the water in tank has been used out 15 minutes, the system will open
electromagnetic valve to supply water until the water level reach the pre-set
value.
(2)It will stop automatically in 10 seconds after water reach the pre-set level.
6.Pipeline antifreeze (optional function)
(1)Function choice
A:Cut off electric power, pick the switch of back cap wiring onto antifreeze
side.
B:Switch on machine, sustainablly press key enter the mode of
anti-freeze( ),pump( )choice , press key until antifreeze sign flickers,
it means electricity heating belt has been chosen. Read more operation details in
the section of Parameters setting .
(2)Press key , the sign displays, it shows pipeline's electricity heating
belt start work.
(3)To prevent electricity heating belt from aging while it works all the time, the
controller is supplied with electricity intermittently, working for 45 minutes then
off for 15 minutes. When is flickering, it means electricity heating belt
suspends.
7.Pump(optional function)
(1)Function choice
A:Cut off the power, pick the switch of back cap onto pressure side.
B:Power on, continually press key into the mode of anti-freeze( ),
pump( ) , press key until pressure sign flickers, it means pump has
been chosen. Read more operation details in the section of Parameters
setting .
7