Using Instruction; Switch On/Off The Controller And Parameters Setting - Haier QBJ1-130A58E Instructions For Use Manual

Using Instruction

10.Anti-dry heating: when the water level in water tank doesn't reach the second
level and user press
to protect the electric heater from damage. At this time, water supply will
automatically activate to supply water until the water reaches the second level,
then electric heater will be activated automatically.
11.Vacuum tube anti-bombing: when water temperature is higher than 90
and there is no water in tank, water supply can't be activated.
12.Safety protection: there are creepage protection and over-temperature power
off and other protective functions.
13.Electricity heating belt controlling: when outdoor subfreezing temperature
occur, start up electricity heating belt to prevent pipe from crack. If you chooses
this function, electricity heating belt needs to be equipped.
14.Pump controlling: this function can be used in low hydraulic pressure area.
When the water is being supplied, pump will activate while electromagnetic valve
is opened. After the water tank is full, both of them will be shut down.(if you
Choose this function, pump needs to be equipped )
Notice electricity heating belt and pump are optional functions, you can choose
one of the functions as you need.
Using Instruction

Switch on/off the controller and parameters setting

1.Switch machine on/off
Connect the power, all sign will light and will run self-check then die out totally.
Press key, the buzzer buzzes once, controller will show the temperature,
water level, time etc. The colon of clock flickers once per second. Press
if the screen goes out, it shows that the controller has been closed.
2.Parameters setting:
When controller is switched for the first time, the information of timer, water
supply time, heating time may not meet your requirement, parameters must
be adjusted as per need. Specific adjustment method is shown as follows:
(1)Press key , temperature display will flicker, waiting to be adjusted by
pressing key. If flicker for 10 seconds and no operate, flicker will stop,
key by mistake, the electric heating will not activate
4
key ,