Table of Contents
Advertisement
SERVICING SOLO 3 375 – WIRELESS SLEEP MODE
For Wireless Power
Before storing, servicing, or transporting, deactivate the motor by putting it in sleep mode to ensure the
screen does not deploy or get damaged.
RTS
1. "Discovery" or Sleep Mode: Use a thin tool to hold the button on the back of the remote until the
screen jogs once. Press and hold the UP, STOP, and DOWN buttons at the same time until the screen
jogs again. The motor is now asleep.
Zigbee
1. "Discovery" or Sleep Mode: Use page 16 of these instructions to disconnect the power and safety spacer,
as shown.
2. Reconnecting: To reconnect the power and safety spacer, follow page 20 of these instructions.
RTS and Zigbee
1. Wake-up Mode: Prior to use, wake the screen from sleep.
a. Plug the charger into the wall, connecting the charging cable to the charger and magnetic charging
port on the cassette. The screen will jog up and down once to signal that the motor is now awake.
b. In case the charger does not wake up the screen, use a thin tool to briefly press the motor button
through the small hole just in front of charging port. The screen will jog once to indicate it is awake.
Servicing – Wireless Sleep Mode
thin tool
22
Advertisement
Table of Contents
