Table of Contents
Advertisement
SERVICING SOLO 3 375 – INSPECTING THE ROLL
By removing the cover during installation, inspection of the roll and screen material are possible.
SERVICING NOTES:
•
Depending on the mounting, removal and reinstallation of the screen may be required to access the
end cap locking screw.
•
Before removing the tube, ensure all wireless battery screens are put to sleep. See page 22.
•
A best practice is to remove the screen from the levers to minimize risk to the screen during
servicing; place the screen on a clean, flat surface.
•
Beware of obstructions when removing cover; if there is an obstruction, unlatch the levers,
disconnect wiring, and remove screen off the brackets to service, laying on a clean, flat surface.
1a. To service the Solo 3, begin by loosening the end cap-locking screw on each end cap.
1b. To unlatch the cassette face and access the motor and screen material, hold the end caps level and
push upwards on each side of the cassette face. Unless two installers are available to each unlatch
one side of the cassette face, unlatching one side at a time is recommended.
The cassette face can be felt and heard disconnecting from the locking screw.
Servicing – Inspecting the Roll
end cap locking screw
3/32" allen wrench
14
Advertisement
Table of Contents
