Table of Contents
Advertisement
SERVICING SOLO 3 375 – TUBE INSTALLATION
To reinstall the material roll, begin by seating the motor head into the motor end cap.
1. To ensure correct fit of the motor head, pay particular attention that the rubber noise isolators are
fully seated in their corresponding end cap recesses.
2. Fully depress the spring-loaded idler; pivot the tube until the idler is in-line with the idler bearing.
The idler can be released once it has cleared the edge of the end cap.
NOTE: Reverse roll screen end caps have additional channels; should the idler engage one of these
channels, use a screw driver to depress the idler and shift into the correct bearing.
Servicing – Tube Installation
18
Advertisement
Table of Contents
