Maintenance - Hayward 3478 PLDBL3 Owner's Manual

EN
230 V
Example with
2 spotlights
12 V
5A protection
Spotlight 1
USER GUIDE: LED SPOTLIGHT RGB COLOUR ONLY
The system offers 16 programmes with 11 set colours and 5 automatic atmospheres. It can be controlled manually, either by remote control (433 MHz) or
by power interruption. When the power is interrupted for a short time (less than 3 seconds), the system changes to the following programme. When the
power is interrupted for more than 15 seconds, the light will stay on the last programme used.
Synchronisation of lights (multiple installation): OFF >20s + ON 3-5s + OFF 3-5s + ON.
The remote control can be used when facing the lamp, at a maximum distance of 10 metres. If metal is present near the spotlight or if its depth is too
great, the use of the remote control can be restricted to a very short distance (1 to 2 metres).
For first use, the remote control must be paired with the receiver integrated into the system.
CONFIGURATION OF THE REMOTE CONTROL:
On/Off (O): Power/Standby
Colours (C): access to 11 set colours
Programmes (P): access to 5 atmospheres
Synchro (S): synchronisation of lights (multiple installation)
Battery not included. Directive 2006/66/EC not applicable.

MAINTENANCE:

Genuine Hayward spare parts must be used for part replacements.
The bulb must be replaced out of the water.
Replacement of the light source in this light must only be performed by the manufacturer, their maintenance agent or by a person with an equivalent
qualification.
When the bulb and/or cable is changed, it is recommended that all parts making the device watertight are changed at the same time.
The seal and parts making the device watertight must be replaced when the bulb is replaced. Take care to ensure they are installed correctly.
If the device stops working, the entire LED bulb must be replaced. Do not open or attempt to repair this.
If the supply cable or its sheath is damaged, to avoid an accident they must be replaced by the manufacturer, an Accredited Service Centre or a
qualified technician.
The cable must comply with the following mechanical and electrical requirements: H05RN-F with a minimum cross-section of 2x1.5mm 2 .
END-OF-LIFE DISPOSAL OF BULBS AND REMOTE CONTROL:
The crossed-out bin symbol indicates selective collection of electrical or electronic devices. This means that these devices and their waste
must not be disposed of with household waste but instead must be taken to waste sorting centres. For more information, contact your town hall
or the distributor that you bought the product from. Disposal of electrical and electronic devices in the correct manner helps to avoid potential
damage to the environment and human health, and to conserve natural resources.
5A protection
Spotlight 2
Only use Hayward ® spare parts
L
N
230 V
Example with
1 spotlight
12 V
5A protection
Spotlight 1
7
water
level