Table of Contents
Advertisement
Safety Instructions
1.
Please read the following safety instructions carefully.
2.
Retain this user manual for future reference.
3.
Disconnect the equipment from all electrical outlets before cleaning. Use only a
damp cloth to clean the equipment; do not apply liquid or spray detergents.
4.
For equipment that requires a power supply, users are advised to position the
equipment near an easily accessible power outlet socket.
5.
Protect this equipment from humidity.
6.
Place this equipment on a reliable surface during installation. Dropping or allow-
ing the equipment to fall may cause damage.
7.
The equipment cover openings are necessary for air convection. Protect the
equipment from overheating and do not cover the opening.
8.
Ensure the power source voltage is correct before connecting the equipment to
a power outlet.
9.
Position the power cord away from high-traffic areas. Do not place anything over
the power cord.
10.
All cautions and warnings on the equipment should be noted.
11.
If unused for a long time, disconnect the equipment from the power source to
avoid damage from transient overvoltages.
12.
Never pour liquids into the cover openings. This may cause fire or electrical
shock.
13.
Never open the equipment. For safety reasons, the equipment should only be
opened by qualified service personnel.
14.
If any of the following occurs, have the equipment checked by service person-
nel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment is exposed to moisture.
The equipment is malfunctioning, or does not operate according to the user
manual.
The equipment has been dropped or damaged.
The equipment shows obvious signs of breakage.
15.
Do not leave this equipment in an environment with a storage temperature of
below -20 °C (-4 °F) or above 60 °C (140 °F). This may damage the equipment.
The equipment should be stored in a controlled environment.
16.
A risk of explosion exists if the battery is incorrectly replaced. Replace batteries
only with the same or equivalent type recommended by the manufacturer. Dis-
card used batteries according to the manufacturer's instructions.
The sound pressure level at the operator's position does not exceed 70 dB (A), as
per the IEC 704-1:1982 specifications.
DISCLAIMER: These instructions are provided according to the IEC 704-1 standard.
Advantech disclaims all responsibility for the accuracy of the statements contained
herein.
MIO-2270 User Manual
vi
Advertisement
Table of Contents
