Table of Contents
Advertisement
QubiQ S2500
DMX Operation
To setup up the device, follow the steps below:
Fill the tank (Fluid Tank Capacity 2,3 L). See 6.3. Filling the Tank on page 22 for more information.
Connect the DMX cables before supplying power to the device. See 5.3. DMX Connection on page
18 for more information
Connect the power cable before supplying power to the device. See 4.5. Connecting to Power
Supply on page 17 for more information.
Set the ON/OFF switch (08) to ON.
Wait for the device to heat up. This will take a maximum of 3 minutes. When the device is not 100 %
heated you cannot view the menu or change the settings.
Set the DMX starting address of the device in Address menu. See 5.3.4. DMX Addressing on page 20
and 6.7.4.1. Address on page 32.
Notes:
●
You cannot constantly fog @100% until the tank is empty.
In order to constantly fog, you have to adjust the output volume to 40%. Only then will the device
keep fogging until the tank is completely empty.
●
The remote control always has priority over manual operation with the control panel on the device.
You are not able to use the buttons on the device, when the remote is plugged in.
DMX Channels
1 CH
Function
1
Output
Product code: 61062
Value
Setting
000–255
Fog output 0-100%
40
Advertisement
Table of Contents
