Table of Contents
Advertisement
Connecting to Power
The R980AT-L Tire Changer must be connected to a 110 VAC power source on a
Amp circuit
The R980AT and R980XR Tire Changers must be connected to a 208-240 VAC power source, on a
dedicated 15 Amp circuit
A Power Cord with
certified Electrician either:
•
Wire the R980AT or the R980XR Power Cord to an appropriate 208-240 VAC NEMA, 30 Amp
Plug, which is then plugged in to an appropriate power outlet.
or
•
Wire the Tire Changer directly into the facility's electrical system protected by an appropriate circuit
breaker.
Important:
Refer to
Wiring Information
⚠
DANGER
Additional electrical information:
•
Operation with no Ground can damage electronics and could create a shock hazard.
ground the unit
•
Damage caused by improper electrical installation voids the warranty.
•
The Tire Changer uses pneumatic and electrical energy; if your organization has Lockout/Tagout
policies, make sure to implement them after connecting the unit to the power source.
•
Make sure that adequate wire sizes are used, service is of adequate amperage rating, the supply
line has the same electrical characteristics (voltage, cycle, and phase) as the motor, and that
other equipment is operated on the same circuit
•
Electrical codes in your area may require "hard-wiring" if the machine is anchored to the floor.
Consult a licensed Electrician regarding the applicable codes for your location.
⚠
WARNING
R980 Series of Tire Changers
. The 110 VAC Unit's power cord is prewired with a plug.
.
no Plug
on the end is provided with the 220 VAC unit. You must have a licensed,
The Tire Changer uses pneumatic and electrical energy; if your organization has
Lockout/Tagout policies, implement them once the unit is connected to a power
source.
for additional wiring information.
All
electrical work
all local, state and National Electrical Codes (NEC). If you do not use a licensed,
certified Electrician, you void your warranty and put everyone who uses the Tire
Changer in danger of injury or, in rare cases, death.
.
Disconnect power and air pressure before performing any
troubleshooting or maintenance
until you are done. This equipment has internal arcing or sparking parts that should
not be exposed to flammable vapors. The unit must
area or below floor level.
must
be done by a licensed, certified Electrician in accordance with
. Make sure the unit cannot be reenergized
19
dedicated 20
.
not
be located in a recessed
P/N 5900158 — Rev. F - March 2022
You must
no
Advertisement
Table of Contents
