Table of Contents
Advertisement
Finding a Location
Keep the following in mind when deciding on a location:
•
Power source. The Tire Changer needs to be near an appropriate power source.
•
Floor. The Tire Changer is best used on a flat, Concrete floor.
•
Clearance. The Tire Changer requires space around it. Refer to
information.
•
Accessibility. You need some space to move the Wheels and Tires to and from the Tire
Changer.
•
Danger. When a Tire is on the Tire Changer, especially during Inflation, you need to keep
everyone far away from it; only the Operator should be within 30 feet of the Tire Changer when it is
in use.
Do not set up the Tire Changer in a well-travelled area
•
No water. The Tire Changer has electrical components. If the Tire Changer gets wet while power
is applied, those electronic components will most likely short circuit and have to be replaced.
⚠
WARNING
Clearance
A certain amount of space around the Tire Changer is required.
You also need room
additional 12 inches / 305 mm of open space
⚠
WARNING
Top view. Not to scale.
R980 Series of Tire Changers
Do not use the Tire Changer if it is sitting in water. You will almost certainly short
circuit the electronic components in the Tire Changer and you could electrocute
yourself or bystanders.
above
the Tire Changer. BendPak Ranger recommends leaving at least an
The Clearance values shown below allow enough space to operate the Tire
For safety purposes, only the Operator should be within 30
Changer.
feet of the Tire Changer while it is in use.
above
the highest point of the Tire Changer.
12
Clearance
for more
.
P/N 5900158 — Rev. F - March 2022
Advertisement
Table of Contents
