Ranger R980AT-L Installation And Operation Manual page 24

View is inside of the Tire Changer, with Side Panel removed. Not to scale. Not all components
shown.
11. Cut the short Tubing piece in the middle.
12. Take the Tee Connector end of the New Air Hose and connect it at two places where you cut the
short Tubing piece, as shown above.
13. Route the rest of the New Air
Hose towards the rear of the
inside of the Tire Changer.
14. Find an unused hole on the
back panel of the Tire Changer.
Refer to the figure on the right.
Look just above where the blue
and orange lines come out of
the inside of the Tire Changer;
see drawing on next page.
15. Push the New Air Hose through
the hole.
You may need to remove the
Straight Connector from the
end of the New Air Hose to get
it through the hole.
16. Route the rest of the New Air
Hose up the back side of the
Main Tower, putting it through
the bottom Vertical Steel Tube
(where there are three Vertical
Steel Tubes).
Rear view. Not to scale. Not all components shown
R980 Series of Tire Changers
24
P/N 5900158 — Rev. F - March 2022