Table of Contents
Advertisement
Chapter 1 Maintenance
5.2
Upon Starting EXPRESSBUILDER
[?]
Unable to start EXPRESSBUILDER
Did you insert the EXPRESSBUILDER DVD and reboot while POST was being executed?
→
Insert the EXPRESSBUILDER DVD into optical disk drive, and reboot the server.
Are BIOS settings correct?
→
Configure the boot order so that the optical disk drive will be the first to start up.
(Check menu: Boot)
Is a message such as the following displayed?
→ Take an appropriate action according to the on-screen message.
This EXPRESSBUILDER version is
not designed for this computer.
Insert the correct version and
click [OK].
EXPRESSBUILDER could not get the
hardware parameters of this
motherboard.
This version is not designed for
this computer or the motherboard
may be broken.
The file that EXPRESSBUILDER
tried to operate was not found.
The file that EXPRESSBUILDER
tried to operate was not able to
open.
EXPRESSBUILDER can not get the
parameters of the definition
file.
An undefined error occurred.
[?]
The following message appears and EXPRESSBUILDER failed to start.
Did you press <Enter> key consecutively twice or more when selecting "Os installation *** default ***"?
→ Press the <Enter> key while selecting "Windows Setup [EMS Enabled]".
Message
This EXPRESSBUILDER
version is not designed for this
computer.
EXPRESSBUILDER could not
find the hardware information
on motherboard.
Failed to read a file or folder in
EXPRESSBUILDER.
Internal error occurred.
Express5800/E120d-M Maintenance Guide
Cause
Use EXPRESSBUILDER
provided with the server. If the
same error persists, contact
your service representative.
Contact your sales
representative.
Media may be defective or the
optical disk drive may be
faulty.
Contact your sales
representative.
5. Troubleshooting
Solution
23
Advertisement
Table of Contents
