Auto Maintenance - HIKVISION DS-7608NI-M2 Series User Manual

2. Select the restore type from the following three options.
Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the
factory default settings.
Factory Defaults
Restore all parameters to the factory default settings.
Restore to Inactive
Restore the recorder to inactive status.
Note
The recorder will reboot automatically after restoring to the default settings.

15.11 Auto Maintenance

The device will automatically restart according to the maintenance plan.
Steps
1. Go to Maintenance → System Service → System Service → Device Auto Maintenance.
2. Check Enable.
3. Set Maintenance Time.
4. Click Apply.
Network Video Recorder User Manual
Figure 15-20 Restore Default Settings
Figure 15-21 Auto Maintenance
160