Configure Email - HIKVISION DS-7608NI-M2 Series User Manual

12.4 Configure Email

The system can be configured to send an e-mail notification to all designated users when a
specified event occurs such as when an alarm or motion event is detected, or the administrator
password is changed, etc.
Before You Start
The device must be connected to a local area network (LAN) that contains an SMTP mail server.
The network must also be connected to either an intranet or the Internet depending on the
location of the email accounts to which you want to send notifications.
Steps
1. Go to System → Network → Advanced → Email.
2. Configure the email settings.
Server Authentication
Check to enable the function if the SMTP server requires user authentication and enter the
user name and password accordingly.
SMTP Server
The IP address of SMTP Server or host name (e.g., smtp.263xmail.com).
SMTP Port
The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL/TLS
Check to enable SSL/TLS if required by the SMTP server.
Sender
The sender's name.
Sender's Address
The sender's address.
Select Receivers
Select the receiver. Up to 3 receivers can be configured.
Receiver
The receiver's name.
Receiver's Address
The email address of the user to be notified.
Attached Image
Check to send email with attached alarm images. The interval is the time between sending
two subsequent alarm images.
Interval
The time interval for capturing the attached images.
Network Video Recorder User Manual
120