Configure Email Linkage; Configure Audio Alert; Trigger Alarm Output - HIKVISION DS-7608NI-M2 Series User Manual

4. Select Notify Surveillance Center.

6.5.4 Configure Email Linkage

The system can send an email with alarm information to a user or users when an alarm is
detected.
Steps
1. Go to System → Network → Advanced → Email.
2. Set the email parameters.
3. Click Apply.
4. Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
5. Select Send Email alarm linkage action.

6.5.5 Configure Audio Alert

When an alarm is triggered, an audio file will be played as the linkage action. The audio file can be
customized. Refer to Audio Management for details.
Before You Start
Ensure the audio files are imported to the device.
Steps
Note
This linkage action is only available for certain events.
1. Check Audio Alert in Normal Linkage.
2. Click to select audio file.
3. Select an audio file.
4. Set arming schedule.
5. Click OK.
6. Click Apply.

6.5.6 Trigger Alarm Output

The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and any all other events.
Steps
1. Go to Linkage Action interface of the alarm detection (e.g., motion detection, face detection,
line crossing detection, intrusion detection, etc.).
2. In Trigger Alarm Outputs area, select the alarm output (s) to trigger.
3. Go to System → Event → Normal Event → Alarm Output.
Network Video Recorder User Manual
82