Table of Contents
Advertisement
i
13. Installation
The SpeedTimer is intended for flush-mounting. We recommend
using a deep box.
You will need:
1 x 58 mm flush-mounted box
2.
1.
1.
2.
3.
4.
5.
6.
7.
3.
Installation procedure:
Switch off the mains.
Make the electrical connection according to the wiring diagram
(see page 16).
Route the power cables to the flush-mounted box.
Slide the installation housing (3) into the flush-mounted box
and screw in place with the screws.
Fit the frame (2).
Carefully insert the operating unit (1) into the installation
housing (3).
Switch the mains power back on again.
Mounting the light sensor, see page 33
EN
17
Advertisement
Table of Contents
