Table of Contents
Advertisement
3
Right-click the network adapter you are going to use and select
shortcut menu.
4
On the list of connections, select
5
Select
Use the following IP address
•
: 157.237.14.12
IP Address
Any address can be used, but 157.237.15.12 is recommended for legacy reasons.
This is particularly important if your system contains old GPT transceivers.
•
: 255.255.0.0
Subnet mask
You can leave
saying that the message subnet mask is missing, select
subnet mask is then automatically generated.
6
Select
to save the selected settings, and then close all the dialog boxes.
OK
7
Start the echo sounder program.
8
Open the
Transceiver Installation
a
Open the
Setup
b
On the
Setup
c
On the left side of the
9
Under
Transceiver Browsing
Ethernet adapter, from the list.
10 At the bottom of the page, select
11 Turn each transceiver off and on.
This forces the echo sounder system to assign new IP addresses within the selected
IP range.
Related topics
Setting to work, page 37
Setting up the complete echo sounder
system
Additional tasks are required if you need to set up a complete echo sounder system.
Transducer installation
The transducers you want to use with the echo sounder system must be "installed"
as a part of the software configuration. Which transducers to use depends on the
number of transceivers in your system, and the licenses you have for these. Unless
you replace a broken transducer, or add a new one, you only need to do this once.
110-0007509/A
Internet Protocol 4 (TCP/IPv4)
, and type the IP address and network mask.
blank and select
Subnet mask
page.
menu.
menu, select
Installation
Installation
, select the IP Address that you just specified for the
Apply
. When you see an error message
OK
OK
.
dialog box, select
Transceiver
to save your settings.
Setting to work
on the
Properties
, and then
.
Properties
again. A default
.
43
Advertisement
Table of Contents
