Table of Contents
Advertisement
R
R R
B. Outside Air Kit Instructions
Parts Included in Kit: 1 piece of 2 inch x ft. flex hose,
1 hose clamp and 1 rodent screen.
Tools Needed: Phillips head screw driver; wire cutters;
hole saw or jig saw.
1. Measure distance from floor to air vent opening in appli-
ance and mark location on wall.
2. Use saw to cut opening in wall. Cut a 2-1/2 to inches
(64-76mm) opening on inside wall and a to -1/2 inch
(76-89mm) opening on outside of house.
. Use hose clamp to secure flex pipe to collar assembly.
4. Slide trim ring over flex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second
hose clamp.
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
CAUTION
Never draw outside combustion air from:
•
Wall, floor or ceiling cavity
•
Enclosed space such as an attic or garage
Attach hose clamp to
intake air collar
Figure 19.1
Hose Clamp
Collar
Assembly
Figure 19.2
October 26, 2006
Outside air
flex pipe
Flex Hose
7014-083C
C. Adjustable Hopper Options
Depending on your installation, the hopper can be vertically
adjusted up to a maximum of -1/2 inches (89mm) and will
hold an additional 15 lbs of fuel.
To adjust hopper:
1. Using a Phillips head screw drive, remove all the screws
from the top of the hopper securing the top hopper piece
to the bottom hopper piece and insert body.
2. Adjust upward a maximum of -1/2 inches (89mm).
. Mark location for new holes and drill new holes.
4. Secure hopper pieces together using screws removed in
step one.
5. See drawing on page 7, Figure 7.3.
D. Optional Grille Installation
1. Remove grille from packaging.
2. Lift top up.
. Align the holes in the insert with the holes in the grille.
4. Use a Phillips screw driver to secure in place. It will be
necessary to go through the hole in the bag support shelf
to gain access to the screw. Figure 19.3.
5. Lower the top into position.
Bag Support Shelf
Figure 19.3
Trim Ring
Hose Clamp
Termination
Cap Assembly
CB1200-I Pellet Insert
Page 19
Advertisement
Table of Contents
