Table of Contents
Advertisement
Operating & Maintenance Manual
Reassembly
Clean the filter gasket contact area and install the new element.Tighten until the gasket
makes contact with the filter housing. Tighten an additional 1/2 to 3/4 of a revolution.
Start the machine (refer to PRIOR TO STARTING and STARTING THE
MACHINE in the OPERATING INSTRUCTIONS section of this manual)
and check for leakage before the machine is put back into service.
Compressor Oil Separator Element
Refer to the MAINTENANCE CHART in this section for the recommended servicing
intervals.
If, however, the element has to be replaced, then proceed as follows:
Removal
Do not remove the filter(s) without first making sure that the machine
is stopped and the system has been completely relieved of all air
pressure. (Refer to STOPPING THE MACHINE in the OPERATING
INSTRUCTIONS section of this manual).
Disconnect all hoses and tubes from the separator tank cover plate. Remove the drop-tube
from the separator tank cover plate and then remove the cover plate. Remove the
separator element.
lnspection
Examine the filter element. Examine all hoses and tubes, and replace if necessary.
54
CAUTION
!
WARNING
!
Maintenance
Book: 22742944 (3-17-06) Rev. A
Advertisement
Table of Contents
Troubleshooting
