Table of Contents
Advertisement
Operating Instructions
7. Restricted IQ Air Filters: Fault indicator lamp. Indicates shutdown due to dirty
IQ air filters (if equipped).
8. Low Fuel Level: Fault indicator lamp. Indicates shutdown due to low fuel level.
Lamp blinks at low fuel warning.
9. Compressor Malfunction: Fault indicator lamp. Indicates shutdown due to
compressor system fault. Refer to Fault Code List.
10. Low Battery Voltage: Alarm indicator lamp. Indicates battery or charging
system requires service.
11. Engine Malfunction: Engine Fault code. Refer to service card or engine
manual for codes and service requirements.
12. Malfunction Code (4 Digit): Compressor or engine fault. Refer to manual for
list of codes and service requirements.
13. Ether Inject: Injects a measured shot of ether for aid in cold weather starting
of engine.
14. Panel Light Switch: Controls panel lamp # 1.
15. Pressure Control: Momentary contact switch. Allows engine to warm up at low
compressor pressure.
16. Main Power Control Switch: ON/OFF Start Switch.
17. Heaters: ON/OFF Power Switch for regulation and IQ heaters. Prevents freeze
up in cold weather.
18. Hourmeter: Indicates machine operating hours.
19. E-STOP: Emergency Stop Push Button (ESA units only). Push to stop, turn to
release.
20. Discharge Air Pressure Gage: Indicates pressure in receiver tank, normally
from 0 psi(kPa) to the rated pressure of the machine.
21. Engine Tachometer: Indicates engine speed in RPM from 0 when stopped to
full speed.
22. Engine Water Temp
23. Fuel Level Gauge: Not used on "S" Models.
24. Compressor Oil Temp
25. Engine Oil Pressure
26. Battery Voltage
Book: 22742944 (3-17-06) Rev. A
CAUTION
!
Use Sparingly.
Operating & Maintenance Manual
33
Advertisement
Table of Contents
Troubleshooting
