Thermo King T-1000R Series Maintenance Manual page 113

Engine Maintenance
NOTE: The two inside sets of adjustment
steps are for single temp units with
reciprocating compressors and multi-temp
units with scroll compressors. The two
outside sets of adjustment steps are for single
temp units with scroll compressors and
multi-temp units with reciprocating
compressors.
1
2
1. Factory Setting Steps (New Belt)
2. Field Reset Setting Steps (2,000 Hours)
Figure 199: Alternator/Motor (Jackshaft) Bracket
Adjustment Steps for T-600R and T-800R Units
112
2
1
1
2
1. Factory Setting Steps (New Belt)
2. Field Reset Setting Steps (2,000 Hours)
Figure 200: Alternator/Motor (Jackshaft) Bracket
Adjustment Steps for T-1000R Units
6. Tighten the locknut that fastens the
alternator/motor (jackshaft) bracket to
alternator clevis bracket.
7. Tighten the locking bolt, which fastens the
alternator/motor (jackshaft) bracket to
alternator clevis bracket.
8. Tighten the alternator pivot bolt.
9. Tighten the three alternator link bolts.
Replacement
1. Loosen the three alternator link bolts (see
Figure 196).
2. Loosen the alternator pivot bolt (see Figure
197).
3. Loosen the locking bolt, which fastens the
alternator/motor (jackshaft) bracket to
alternator clevis bracket (see Figure 197).
4. Loosen the locknut that fastens the
alternator/motor (jackshaft) bracket to
alternator clevis bracket (see Figure 198).
5. Back the alternator adjusting bolts out of the
alternator/motor (jackshaft) bracket about 3
in. (76 mm).
2
1