Table of Contents
Advertisement
INDEX
WARNING
Escaping hydraulic fluid can cause serious
personnel injury. Relieve system pressure before
repairing, adjusting, or disconnecting. Wear
proper hand and eye protection when searching
for leaks. Use cardboard instead of hands
Figure
4-2) Keep all components (cylinders,
hoses, fittings, etc.) in good repair.
1. The hydraulic system will be filled with oil and fully
charged. Carefully hitch the AG11/13 to the tractor
and connect the hydraulic lift hoses. Check to make
sure the tractor hydraulic reservoir is full of the
manufacturer's recommended oil. Lower and raise
the unit to verify that the system is operating
correctly. Recheck tractor reservoir to make sure it is
within operating limits. With the lift cylinder fully
extended, install the 6 x 22 transport lockout
Figures
4-3. Storage location for lockout
Figures
4-3.
3 X 5/32
BRIDGE PIN
TABLE OF CONTENTS
2. Always fully extend lift cylinder before removing
transport lockout. Unit can settle during
transportation causing the transport lockout to be
pinched.
(See
See
See
1/2 X 4-1/2
CLEVIS PIN
Figure 4-3: Transport Locks
HOOKUP AND OPERATION
6 X 22 TRANSPORT,
LOCK INSTALLED POSITION
6 X 22 TRANSPORT LOCK,
STORED POSITION
3 X 5/32
BRIDGE PIN
4-3
Advertisement
Table of Contents
