Cisco AS5400 Installation Manual page 56

Online Insertion and Removal (OIR) of the Universal Port DFC
Seat the DFC in the carrier by pushing the card firmly until the captive screws are aligned with their
Step 4
holes.
Tighten the screws to secure the DFC to the chassis. (See
Step 5
Figure 5-11 Tighten the Captive Screws on the Cisco AS5350
Figure 5-12 Tighten the Captive Screws on the Cisco AS5400
Step 6 Check the card LEDs to verify that the card is working properly. For information about dial feature card
LEDs, refer to
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
5-8
DFC
Captive
screw
Captive
screw
Captive
Captive
screw
screw
Chapter 6, "Troubleshooting"
Figure 5-11
Carrier card
Chapter 5 Universal Port Dial Feature Card
and Figure 5-12.)
Chassis
78-13311-01