Cisco AS5400 Installation Manual page 43

Chapter 4 T3 Dial Feature Card
Figure 4-3
Initialize the software busyout procedure by entering the busyout command:
Step 2
Router# busyout
Enter the show busyout command to check busyout status for that specific slot:
Step 3
Router# show busyout
You may use the clear port command to immediately disable active calls on the universal port card. Use
Step 4
the show controller command to show the universal port card associated with the T1 or E1 DFC.
Router# show controller t1/e1
Router# clear port
Note
Verify that the OIR/MAINT LED is off; this indicates that the DFC is offline and ready to be removed.
Step 5
Note
Attach an ESD-preventive wrist strap.
Step 6
Do not work on the system or connect or disconnect cables during periods of lightning activity. To
Warning
see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information document that accompanied this device.
Disconnect all interface cables from the DFC and secure them out of the way.
Step 7
Note
78-13311-01
Slot Numbering on the Cisco AS5400 Chassis
Slot 0 Slot 1
Slot 2 Slot 3
Slot 4
Slot 6
slot-number
slot-number
slot-number/port number
The clear port command only applies to the universal port DFC.
The OK/MAINT LED is green before you enter the busyout command. After you enter the
busyout command, the LED changes to yellow. The LED turns off after all calls are
disconnected and resources are taken out of service, indicating that busyout is complete.
OIR of the T3 DFC is similar to that of the T1 or E1 DFC. To see an example of the output
during online insertion and removal of an E1 DFC refer to
Feature Cards"
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
Online Installation and Removal (OIR) of the T3 DFC
Slot 5
Slot 7
slot-number/control-number timeslot-number
timeslot
Chapter 3, "T1 and E1 Dial
4-3