Cisco AS5400 Installation Manual page 36

Online Installation and Removal of the T1 or E1 DFC
Figure 3-12 Install the T1 or E1 DFC in the Cisco AS5400
Align the captive screws with their holes, and seat the card completely.
Step 3
Tighten the screws to secure the DFC to the chassis. (See
Step 4
Figure 3-13 Tighten the Captive Screws on the Cisco AS5350
Figure 3-14 Tighten the Captive Screws on the Cisco AS5400
Check the card LEDs to verify that the card is working properly. For information about dial feature card
Step 5
LEDs, refer to
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
3-10
0
1
Rx
Tx
ACT
Captive
DFC
Captive
screw
screw
Captive
Captive
screw
screw
Chapter 6, "Troubleshooting"
Figure 3-13
2 PRI
OK
Carrier
card
Chapter 3 T1 and E1 Dial Feature Cards
and Figure 3-14.)
Chassis
78-13311-01