Basic Maintenance Schedule - Generac Power Systems MLT6SC Owner's Manual

Maintenance
•
Verify safety pins for the mast lock rod and mast
lock bar are present and secured with a chain.
Verify spring located in the mast lock bar is not
broken or missing. Check operation of the mast
lock bar.
•
Verify wheel lugs are present and properly
tightened. Refer to
•
Check coolant level daily by inspecting the level in
coolant overflow jug located near radiator. Refer to
the engine operator's manual for coolant recom-
mendations and proper mixture. Normal operating
level is between the FULL and ADD markings on
the overflow jug.
•
After engine is stopped and completely cool, cool-
ant may be added directly to coolant overflow jug.
•
Check oil level daily. Refer to the engine operator's
manual for the appropriate oil specification. Verify
oil is correct for special operating conditions such
as a change in season or climate.
• DO NOT start unit if engine oil level is below
the ADD mark on the oil dipstick.
• Normal operating level is within the cross-
hatch pattern between the FULL and ADD
markings on the oil dipstick.
• Only add oil if oil level is below the ADD mark on
the bottom of the cross-hatch pattern on the oil
dipstick. DO NOT OVERFILL the crankcase.
•
Check fuel level.
•
If unit is connected to a remote start or transfer
switch, verify the remote switch is also off and
tagged.
NOTE: If engine was run out of fuel, or fuel tank was
drained, it may be necessary to purge the fuel lines.
Refer to the engine operator's manual supplied with the
unit.
36
Towing Safety.

Basic Maintenance Schedule

Refer to the original equipment manufacturer's operating
manual for a complete list of maintenance requirements.
Failure to comply with the procedures as described in the
engine operator's manual will nullify the warranty,
decrease performance, and cause equipment damage or
premature equipment failure. Maintenance records may
be required to complete a warranty request.
Use the schedule in the following table as a guide for reg-
ular maintenance intervals. For additional or replacement
copies of the engine operator's manual, contact a GMP
ASD.
Owner's Manual for MLT6SC Light Tower