Operator Screens - Generac Power Systems MLT6SC Owner's Manual

General Information

Operator Screens

See Figure 2-14. The operator screens display the most
relevant and critical information an operator will need to
properly configure and use the unit. From these six
screens, the operator can access information necessary
to operate the unit under normal conditions.
Figure 2-14. Operator Screens Location
Home Screen
See Figure 2-15. The Home screen is the default screen
of the controller and displays after the controller is
powered up and the unit management software is
loaded. It displays the controller mode, total operating
hours, hours left until the next service interval, engine
operating status, and engine rpm. If the unit is in AUTO
mode, the Home screen may also display whether the
scheduler or "dusk to dawn" are enabled.
Figure 2-15. Home Screen
20
Battery Voltage Screen
See Figure 2-16. Displays the engine battery voltage. A
normal reading is 13.5–14.8V on 12 volt systems (with
the engine running).
Figure 2-16. Battery Voltage Screen
Lights Screen
See Figure 2-17. The Lights screen enables the operator
002354
to turn the lights on and off. Refer to
more information.
002544
Light Operation
Figure 2-17. Lights Screen
Owner's Manual for MLT6SC Light Tower
002990
for
002327