Table of Contents
Advertisement
Operation
6. See Detail E. Rotate each jack handle clockwise to
start leveling the trailer. Adjust all three jacks by
rotating the handles clockwise until they are firmly
in contact with the ground. Continue until the
wheels are approximately 1 in (2.5 cm) off the
ground (G).
7. Before raising the mast, it may be necessary to
adjust the lamps. The lamps may be adjusted up,
down, left or right by simply aiming them in the
desired direction.
Prestart Checklist
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Before starting the unit, all items in the prestart checklist
must be completed. This checklist applies to both manual
and remote starting of the unit.
Verify all maintenance procedures are up to date. For
more information, refer to
Basic Maintenance
The unit must be level.
The unit must be dry. Inspect for water inside or near
the unit; dry if needed.
For grounding requirements, follow the local, state, or
National Electrical Code (NEC) regulations.
Verify the control power switch is OFF (O).
Verify all circuit breakers are OFF (O).
Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.
Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.
Check oil, coolant, and fuel levels. For more
information, refer to
General
Verify battery connections are secure.
Turn the battery disconnect switch on, if equipped.
Inspect the engine fan belt tension and condition.
Inspect the engine fan belt guard.
Inspect the engine exhaust system for loose or
rusted components.
Verify all covers are in place and secure.
26
(000100a)
General Maintenance
Schedule.
Maintenance.
Raising the Mast—Manual Winch
Electrocution. DO NOT use the unit if
electrical cord is cut or worn through. Doing
so will result in death or serious injury.
Tipping hazard. Extend the outriggers and level the unit
before raising the mast. Keep the outriggers extended while
the mast is up. Failure to do so could cause the unit to tip
and fall and could result in death or serious injury.
Tipping hazard. Do not extend the mast beyond the
colored mark on the second mast section. The unit
can become unstable and tip or fall, causing injury.
and
Personal Injury. Stop immediately if the mast hangs
up or the winch cable develops slack. Excess slack
could cause the mast to collapse, resulting in personal
injury or equipment damage.
Personal injury or equipment damage. Do not raise
or lower the mast while the unit is operating.
Doing so can break the lenses and cause the
lamps to shatter.
1. Set up and level the unit. See
2. See
Figure
excessive wear or damage. Verify the cables are
properly centered in each pulley (A). Inspect the
electrical cord for damage.
DANGER
WARNING
WARNING
WARNING
WARNING
Light Tower
3-2. Inspect the mast cables for
Owner's Manual for MLT6SC Light Tower
(000263a)
(000266)
(000262)
(000265)
(000279)
Setup.
Advertisement
Table of Contents
Troubleshooting
