Basic Maintenance Schedule - Generac Power Systems MAGNUM MLT4200IVF4 Owner's Manual

Light tower

Hide thumbs Also See for MAGNUM MLT4200IVF4:

Owner's manual (59 pages)

Table Of Contents

Table of Contents

Maintenance

•

Verify the safety pins for the mast lock rod and

mast lock bar are present and secured with a

chain. Check that the spring located in the mast

lock bar is not broken or missing. Check the

operation of the mast lock bar.

•

Verify the wheel lugs are present and properly

tightened. Refer to

•

Check the coolant level daily by inspecting the

level in coolant overflow jug located near the

radiator. Refer to the engine operator's manual for

coolant recommendations and proper mixture.

Normal operating level is between the 'full' and

'add' markings on the overflow jug.

•

AFTER ENGINE IS STOPPED AND COMPLETELY

COOL, coolant may be added directly to the coolant

overflow jug.

•

Check the oil level daily. Refer to the engine

operator's manual for the appropriate oil specification.

Make sure that the oil is correct for special operating

conditions such as a change in season or climate.

• DO NOT start the unit if the engine oil level is

below the ADD mark on the dipstick.

• Normal operating level is in the cross-hatch

pattern between the full and add markings on

the dipstick.

• Add oil only if the oil level is below the add mark

on the bottom of the cross-hatch pattern on the

dipstick. DO NOT OVERFILL the crankcase.

•

Check the fuel level.

•

If the unit is connected to a remote start or transfer

switch, verify the remote switch is also off and

tagged.

NOTE: If the engine was run out of fuel or the fuel tank

was drained, it may be necessary to bleed the fuel lines.

Refer to the engine operator's manual supplied with the

unit.

Towing

Safety.