Figure 5-11 | Virtual Keypad - Acom 2020S User Manual

DHCP (Dynamic Host Configuration Protocol)
-
If DHCP is selected, the fields IP ADDRESS, SUBNET MASK, GATEWAY and DNS are
disabled and cannot be edited, however they remain visible so the user is able to
review the settings.
IP ADDRESS
•
This parameter is used to set the IP address for ACOM 2020S in your LAN network. This
parameter is disabled when DHCP is selected in parameter IP ADDRESS ASSIGNMENT.
SUBNET MASK
•
This parameter is used to set the Subnet Mask address for ACOM 2020S in your LAN network.
This parameter is disabled when DHCP is selected in parameter IP ADDRESS ASSIGNMENT.
GATEWAY
•
This parameter is used to set the Gateway address for ACOM 2020S in your LAN network. This
parameter is disabled when DHCP is selected in parameter IP ADDRESS ASSIGNMENT.
DNS (Domain Names System)
•
This parameter is used to set the DNS address for ACOM 2020S in your LAN network. This
parameter is disabled when DHCP is selected in parameter IP ADDRESS ASSIGNMENT.
If Wi-Fi is selected in parameter NETWORK MODE, two additional fields appear:
SSID (Service Set Identifier)
•
Here you can enter the ID (name) of the wireless network you are connecting the device to;
NETWORK KEY
•
Here you can enter the required by the wireless network key/password (if any).
Page 52 of 76 | S e c t i o n MENUS - SETTINGS AND SERVICE FUNCTIONS
User's Manual | ACOM 2020S | 1.8-54 MHz Linear Power Amplifier

Figure 5-11 | Virtual keypad

Figure 5-11 | Virtual keypad
June 2022