Wslog - HP 48gII Advanced User's Reference Manual

• x and x
left
• y and y
near
• z and z
low
• x and x
min
• y and y
min
• x , y
eye eye
viewed.
• x and y
step
coordinates plotted.
The plotting parameters are specified in the reserved variable PPAR, which has this form:
For plot type WIREFRAME, the elements of PPAR are used as follows:
• (x , y
min
• (x , y
max
• indep is a name specifying the independent variable. The default value of indep is X.
• res is not used.
• axes is not used.
• ptype is a name specifying the plot type. Executing the command WIREFRAME places the
command name WIREFRAME in ptype.
• depend is a name specifying the dependent variable. The default value is Y.
...µ
Access:
Input/Output: None
See also: BAR, CONIC DIFFEQ, FUNCTION, GRIDMAP, HISTOGRAM, PARAMETRIC,
PARSURFACE, PCONTOUR, POLAR, SCATTER, SLOPEFIELD, TRUTH, YSLICE

WSLOG

Type: Command
Description: Warmstart Log Command: Returns four strings recording the date, time, and cause of the four
most recent warmstart events.
Each string "log
of code and their meanings.
Code
0 The warmstart log was cleared by pressing $†.
1 The interrupt system detected a very low battery condition at the battery contacts
(not the same as a low system voltage), and put the calculator in "Deep Sleep
mode" (with the system clock running). When $ is pressed after the battery voltage
is restored, the system warmstarts and puts a 1 in the log.
2 Hardware failed during transmission (timeout).
3 Run through address 0.
4 System time is corrupt
5 A Deep Sleep wakeup (for example,
6 Not used
are real numbers that specify the width of the view space.
right
are real numbers that specify the depth of the view space.
far
are real numbers that specify the height of the view space.
high
are not used.
max
are not used.
max
, and z are real numbers that specify the point in space from which the graph is
eye
are real numbers that set the number of x-coordinates versus the number of y-
step
{ (x
, y
min min
) is not used.
min
) is not used.
max
WIREFRAME
" has the form "code–date time". The following table summarizes the legal values
n
) (x ) indep res axes ptype depend }
, y
max max
Description
$ , Alarm).
Full Command and Function Reference 3-199