1
2
2
1
3
9 . Case Unit
Required jigs and tools: Electric screwdriver (Driver bit 2)
1
(1) Turn off the printer and unplug it from the electri-
1
(2) Remove the inner cover, lens and the fLED PCBs to the
(3) Removal
1
10 . Platen Unit
Required jigs and tools: E-ring holder 4.0
(1) Turn off the printer and unplug it from the electrical
(2) Open the front panel to the procedure described in item 1.
(3) Open the front cover unit to the procedure described in
(4) Removal
– 10 –
cal outlet.
procedure described in item 8.
• Four screws 1
[ Tightening torque : 0.8±0.2 N . m]
• Case unit 2
E-ring dispenser 4.0
outlet.
item 7.
• Stop ring 1
• PF roller bearing 2
• Platen unit 3
Note: When assembling, be sure to always use a new
stop ring. Never reuse one.