Inner Cover / Lens / Led Pcb - Star Micronics AsuraCPRNT Technical Manual

2
5
5
1
1
LED facing out
LED PCB Cable
C
Cutter Cable
2
3
2
4
LED PCB Cable
C
PF Motor Cable
– 9 –
8 . Inner Cover / Lens / LED PCB
Required jigs and tools: Electric screwdriver (Driver bit 2)
(1) Turn off the printer and unplug it from the electri-
cal outlet.
(2) Remove the front cover unit to the procedure described
in item 7.
(3) Removal
• Two connectors 1
• Four screws 2
[ Tightening torque : 0.8±0.2 N . m]
• Inner cover 3
• Lens 4
• Two LED PCBs 5
[ Caution in assembly ]
• Check the directions when installing the two LED
PCBs.
• Align the 14 holes on the case with the lens boss.
• Route the LED PCB cable through the board chassis
(section C) and once around the cutter cable on the
left and the PF motor cable on the right.
• Check that the cover lock unit has not shifted when
you install the inner cover.
Cover Lock Unit