Stationary Knife - Star Micronics AsuraCPRNT Technical Manual

F
2 3
2
8
6
5 1
4
8
8
3
9
7
5
C
0
[ Caution in assembly ]
• Screw in the screws shown in (8) in the order
.
_4
• Check that the cable route for the BM sensor is as
shown in the following illustration, with the ca-
ble passing under the two hooks in section D and
through the two grooves in section E on the front
cover.
OK
D
E
D
1
E
D
8
4
A
9

11 . Stationary Knife

Required jigs and tools: Electric screwdriver (Driver bit 2)
(1) Turn off the printer and unplug it from the elec-
B
trical outlet.
(2) Remove the front cover unit to the procedure de-
scribed in item 7.
(3) Removal
0
• Screw 1
[Tightening torque : 0.5±0.1 N . m]
• Stop ring 2
• PF roller bearing 3
• Platen unit 4
• Two screws 5
[Tightening torque : 0.8±0.2 N . m]
• Earth plate 6
• Upper guide unit 7
• Four screws 8
[Tightening torque : 0.7±0.2 N . m]
• Two springs 9
• Two stop rings 0
• Lever shaft A
• Open lever B
• Open hook C
• Platen holder D
1_2_3
• Two screws E
[Tightening torque : 0.8±0.2 N . m]
• Stationary knife F
Note1: The cutter unit and the stationary knife must
always be replace at the same time.
installation position of the cutter unit , refer to
the item 3.
2: Lubricate the cutter unit after re-placement.
(Refer to item2 of chapter 2.)
3: When assembling, be sure to always use a new
stop ring. Never reuse one.
4: When installing the upper guide unit, make
sure the BM sensor cable is not caught between
the platen holders.
Black Mark Sensor Cable
– 11 –
Electric screwdriver (Driver bit 1)
E-ring holder 4.0
E-ring dispenser 4.0
E-ring holder 3.0
E-ring dispenser 3.0
OK NG
Upper Guide
Platen Holder
For the