Table of Contents
Advertisement
STEERING-IVT
22.
Check the timing of the gear box:
22a. Turn the input shaft until the steering rack
has moved all the way to the left. The right
shoulder should be flush with the housing.
See Figure 6B.74.
Figure 6B.74
22b. Turn the input shaft until the steering rack
has moved all the way to the right. The left
shoulder should be flush with the housing.
23.
Install the return to neutral bracket.
24.
Install the remaining housing screws.
25.
Install the return to neutral bolt.
NOTE: The return to neutral bolt does not need
to be tightened at this time. It will be adjusted
and tightened when it is installed in the tractor.
26.
Center the steering rack and thread a 1/4"-20x2"
bolt into the hole in the gear box to lock the gear
box in neutral.
27.
Install the steering gear box in the tractor and
perform the speed cam adjustment, neutral
adjustments and the wheel alignment by follow-
ing the procedures described in this chapter.
28.
Test drive the tractor in a safe area before
returning to service.
102
Shoulder should be
flush with the housing
Front wheels and axles
Remove/ replace the front wheels:
1.
Lift and safely support the front end of the trac-
tor.
2.
Gently pry off the hub cap. See Figure 6B.75.
Hub cap
Figure 6B.75
3.
Remove and discard the cotter pin.
See Figure 6B.76.
Cotter pin
Figure 6B.76
4.
Remove the washer. See Figure 6B.76.
5.
Slide the wheel off of the axle.
Washer
Advertisement
Table of Contents
