Table of Contents
Advertisement
STEERING-IVT
9.
Remove the input sector gear.
See Figure 6B.42.
Input sector gear
Figure 6B.42
10.
Inspect the input sector gear bushings for dam-
age and/or signs of wear. If they show signs of
wear or damage, press both of the bushings out
of the input sector gear using a press.
See Figure 6B.43.
Press out the
bushings
Figure 6B.43
94
11.
Remove the internal cam and both of the wash-
ers on top of the cam. See Figure 6B.44.
Washers
Steering
shaft
Internal cam
Figure 6B.44
NOTE: The steering shaft is pressed into the
lower housing.
12.
Remove both of the bevel gears.
See Figure 6B.45.
Bevel gears
Figure 6B.45
NOTE: There may be a pocket of suction
between the bevel gear and the lower housing
because of the grease. It may be necessary to
use a pry tool to lift the bevel gear out of the
lower housing.
Advertisement
Table of Contents
